Junger Audio MIX4 Small Desktop Mixer - Manual (Page 47)

Jünger Audio-Studiotechnik GmbH
page 44
4.
Send the Setup “to Device” and power cycle the MIX4 if its IP configuration has changed.
5. Press the “Configuration” soft button on the Router page. This will load the actual router
configuration into the Setup software. Depending on the size of the router, this process may take a few
minutes!
When done a page similar to the one below will appear on the PC screen :
6.
Here you may pre select 16 groups of 8 sources each from the total of thousands of router sources.
The group name can be edited in the “Groupname:” field below the line of group labels (see above).
You may disable a group completely if there is no need for as much as 16 groups for the current
application of the MIX4. This also applies to the sources within a group. If there is no need for as much
as 8 sources per group you should disable the unused ones. The reason for this option is to prevent
the operator from “dialing“ through a number of sources he does not need to do his job.
7.1
Each source for the MIX4 can be selected by a pull down box that opens, if one clicks the triangle soft
button on the left side of the configuration field :