ILUMINARC LΩGIC™ 4X36 - Manual (Page 9)

Installation
LΩGIC™ 4X36 User Manual (Rev. 10)
5
3. Installation
Always connect
the
LΩGIC™
4X36 to a
protected circuit with an
appropriate electrical
ground to avoid the risk of
electrocution or fire.
Never connect
the
LΩGIC™
4X36 to a
rheostat (variable resistor)
or dimmer circuit, even if
the rheostat or dimmer
channel serves only as a
0 to 100% switch.
Make sure to
disconnect the
products power
cord before replacing a
blown fuse, and always
replace it with a fuse of
the same type and rating.
AC Power
The
LΩGIC™ 4X36 has an auto-ranging power supply that can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product’s user manual, or on the product’s sticker.
Power Consumption
To determine the power requirements for the
LΩGIC™ 4X36 see the label affixed to the
side of the product. Alternatively, you may refer to the corresponding specifications chart in
the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
AC Plug
The
LΩGIC™ 4X36 comes with a power input cord terminated with an IEC connector on
one end and an Edison plug on the other end (US market). If the power cord that came with
your product has no plug or you need to change the Edison plug, use the table below to wire
the new plug.
Connection Wire (US) Screw Color (US) Wire (Europe)
AC Live Black Yellow or Brass Brown
AC Neutral White Silver or Gray Blue
AC Ground Green/Yellow Green Green/Yellow
Fuse Replacement
1. With a flat head screwdriver, wedge the fuse holder out of its housing and remove the
blown fuse from its holder.
2. Replace the blown fuse with a fuse of the exact same type and rating.
3. Insert the fuse holder back in its place, and reconnect power.
The fuse is located inside
this compartment.
Remove it using a flat
head screwdriver.