ILUMINARC LΩGIC™ 4X36 - Manual (Page 27)

Technical Information
LΩGIC™ 4X36 User Manual (Rev. 10)
23
5. Technical Information
If the product
has fans, make
sure that you
never spin a fan if
cleaning the product with
compressed air.
Always dry the
external optics
and glass
surfaces carefully
after cleaning them.
If you still
experience
technical
problems after
trying the solutions in the
Troubleshooting Table,
contact ILUMINARC
®
Technical Support.
System Maintenance
To maintain optimum performance and minimize wear, the user should clean the product
frequently. Usage and environment are contributing factors in determining the cleaning
frequency. As a rule, the user should clean the product at least twice a month. Dust build up
reduces light output performance and can cause overheating. This can lead to reduced light
source life and increased mechanical wear.
The cleaning frequency depends on the environment in which the product operates. Damp,
smoky, or particularly dirty surrounding can cause greater accumulation of dirt on the
product’s optics.
To clean a product, follow the recommendations below:
1. Unplug the product from power.
2. Wait until the product is cold.
3. Use a vacuum (or dry compressed air) and a soft brush to remove dust collected on the
external vents and reachable internal components.
4. Apply the solution directly to the cloth or tissue and drag any dirt and grime to the
outside of the product.
Product Repairs
ILUMINARC ® strongly advises you against attempting any repairs to this product unless
you are an authorized ILUMINARC ® technician.
ILUMINARC ® presents the information contained in the Troubleshooting Table as a guide
only. In most cases, opening the product’s housing will invalidate its warranty, unless there
is a written indication to the contrary.