DekTec DTC-300 StreamXpress - Manual (Page 67)

DTC-300-SP – StreamXpress
USER MANUAL
67
4. Using the StreamXpress with the DOS command prompt
For certain applications and uses, it is worthwhile to use the command prompt to start the
StreamXpress. StreamXpress can be option in DOS prompt with some options. These commands will
launch the application with the parameters specified in the options. This can be used for batch file or
on start-up of a computer.
–dte
This command allows starting the StreamXpress with DTE-3100 support (If the DTE-3100 is licensed
and enabled for the StreamXpress)
–play
This command allows starting the StreamXpress and start playing the file previously loaded.
–n xx
This command allows specifying the device number to use.
–hide
This command allows starting the StreamXpress as a process without launching the GUI.
–once
This command allows starting the StreamXpress and play the loaded file one time.
–port xx
This command allows starting the StreamXpress and selects a specific port of the device (If multiple
ports are available).
-rc xxxx
This command allows starting the StreamXpress with the remote control option. Note that the –rc
must be followed by a TCP port number. See SpRcAPI.pdf for more information.
-t xxx
This command allows starting the StreamXpress and specifies which device type to use when multiple
adaptors are present. Possible adaptors include:
100, 102, 107, 110, 111, 112, 115, 116, 117, 140, 145, 160, 205, 245, 545, 2145, 2160 or
3100