DekTec DTC-300 StreamXpress - Manual (Page 38)

DTC-300-SP – StreamXpress
USER MANUAL
38
3.5.9.1 General parameters
This section allows the setting of the general T2 transmission parameters.
Variable Type Description Details Diag
Bandwidth Drop
down
Select the bandwidth of the modulated channel #1 1
FTT mode Drop
down
Select the FFT (Fast Fourier Transfer) mode of the modulation #2 2
Guard Interval Drop
down
Select the guard interval used for the modulation #3 3
L1 Modulation Drop
down
Select L1 Modulation, the constellation of the L1-post signalling
block
#4 4
Pilot pattern Drop
down
Select Pilot Pattern used for the data OFDM symbols #5 5
PAPR Drop
down
Select the PAPR (Peak to Average Power Ratio) reduction if used #6 6
Bandwidth
Extension
Tick box If checked, the extended carrier mode is used #7 7
Freq. Field Center frequency of the RF Channel #8 8
Network ID Field Uniquely identifies the DVB-T2 network #9 9
T2 system ID Field Uniquely identifies a T2 system within the DVB-T2 network #10 10
Cell ID Field Uniquely identifies a geographic cell in a DVB-T2 network #11 11
1
4
2
3
5