CRU Forensic ComboDock v5 - Manual (Page 7)

CRU-WiebeTech
Forensic ComboDock v5 User Manual A9-000-0041 REV 1.0 - 7 -
• A notification will appear on the screen that continuing will end any data
transfer. Make sure no data is being written to or read from the drive,
then press ENTER.
• Use the UP, DOWN, BACK and ENTER buttons to enter the size of the
DCO that you want. Press ENTER.
• Forensic ComboDock will ask you to confirm. If not sure, Press BACK. If
sure, press ENTER.
• Forensic ComboDock will then create the DCO. When complete, you
will be notified to cycle power on the unit.
After Forensic ComboDock is turned off and back on, the DCO exists on the connected drive.
3.5.2 Set HPA Size
From this screen, you can set a new size for HPA (Host Protected Area). Each drive can only have one
such area. Use the navigation buttons to select its size. The disk capacity available to a computer will be
reduced by this amount. A value of zero means no HPA. Values exceeding available capacity are not
accepted.
• From the “View Drive Info” screen, press the UP or DOWN buttons to get
to the “Create HPA/DCO” screen. Press ENTER.
• Press UP or DOWN to toggle between “Set HPA size” and “Set DCO size”
screens. When “Set HPA Size” displays, press ENTER.
• A notification will appear on the screen that continuing will end any data
transfer. If this is OK, press ENTER.
• Use the UP, DOWN, BACK and ENTER buttons to enter the size of the
HPA that you want. Press ENTER.
• Forensic ComboDock will ask you to confirm. If not sure, Press BACK.
If sure, press ENTER.
• Forensic ComboDock will then create the HPA. When complete, you will
be notified to cycle power on the unit.
After Forensic ComboDock is turned off and back on, the HPA exists on the connected drive.
4. USB Mode Switch
There are two USB modes on Forensic ComboDock.
• USB 3.0 Mode: Use this mode when Forensic ComboDock is connected to a USB 3.0 port on
your computer with a USB 3.0 cable (such as the cable included with the product). If Forensic
ComboDock is used with a USB 2.0 port or cable and it is switched to USB Normal mode, the
dock will not function correctly.
• USB 2.0 Mode: This mode ensures that Forensic ComboDock is backwards-compatible with
USB 2.0. In this mode you can use any cable or USB port type, but it will operate at USB 2.0
speed. USB Admin mode should also be used when using CRU applications (such as Forensic
Software Utility) to update the dock.
WILL END ANY
DATA XFER >
DCO SIZE (MB):
00000000>
HPA SIZE (MB):
ARE YOU SURE? >
CREATING DCO
CYCLE POWER NOW
CREATE HPA/DCO:
>
SET HPA SIZE
>
WILL END ANY
DATA XFER >
HPA SIZE (MB):
00000000>
HPA SIZE (MB):
ARE YOU SURE? >
CREATING HPA
CYCLE POWER NOW