CRU Forensic ComboDock v5 - Manual (Page 6)

CRU-WiebeTech
Forensic ComboDock v5 User Manual A9-000-0041 REV 1.0 - 6 -
VIEW DOCK INFO:
>
HPA/DCO AUTO
>
HPA/DCO AUTO
IGNORE ALL >
UNLOCK ALL
NOW DEFAULT
CREATE HPA/DCO:
>
SUPPORTED IN
R/W MODE ONLY
3.3 View Dock Info
This screen displays information about your Forensic ComboDock unit.
• From the “View Drive Info” screen, press the UP or DOWN buttons to get to the “View Dock Info”
screen. Press ENTER.
• Use the UP or DOWN buttons to scroll through and view the following info about Forensic
ComboDock.
3.4 HPA/DCO Auto
This screen allows you to configure the way Forensic ComboDock will automatically handle hidden areas
it detects on drives during power up.
• From the “View Drive Info” screen, press the UP or DOWN buttons to get
to the “HPA/DCO Auto” screen. Press ENTER.
• Press UP or DOWN to scroll through the four ways Forensic ComboDock can handle HPAs
and DCOs.
1) Ignore all - Detects and indicates their presence, but does not
remove them.
2)
Temp Unlock HPA - Temporarily remove HPA only.
3)
Perm Unlock HPA - Permanently remove HPA only
4) Unlock All - Permanently remove any HPA or DCO
• Press ENTER when your desired mode appears on the LED. Forensic
ComboDock will then set your desired mode as the default.
3.5 Create HPA/DCO
You can create an HPA or DCO on the attached drive only if you are in Read-
Write mode. If you try to create an HPA/DCO in Write-Blocked mode, the screen
will display “SUPPORTED IN R/W MODE ONLY.” To create an HPA/DCO, cycle power on the unit and
switch to Read-Write mode.
3.5.1 Set DCO Size
This option is only available if no HPA exists on the drive. It allows you to set a new size for DCO (Device
Configuration Overlay). Each drive can only have one such area. Use the navigation buttons to select its
size. The disk capacity available to a computer will be reduced by this amount. A value of zero means
no DCO. Values exceeding available capacity are not accepted.
• From the “View Drive Info” screen, press the UP or DOWN buttons to get
to the “Create HPA/DCO” screen. Press ENTER.
• Press UP or DOWN to toggle between “Set HPA size” and “Set DCO
size” screens. When “Set DCO Size” displays, press ENTER.
Appearance on LCD Explanation
Product Name Brand name of the product (e.g. “Forensic ComboDock”).
Unique ID#
A specific, unique number assigned to the unit for identification, akin to a
serial number.
Firmware ver. # Firmware version currently installed on the Forensic ComboDock product.
HPA/DCO AUTO
TEMP UNLOCK HPA >
HPA/DCO AUTO
PERM UNLOCK HPA >
HPA/DCO AUTO
UNLOCK ALL >
SET HPA SIZE
>