3 mounting and unmounting volumes, 4 creating a boot drive – CRU RAX840-IR User Manual
Page 11

CRU
4.1.3 Mounting and unmounting volumes
If the hard drives installed in the product are already formatted, an icon representing
the drive’s volume will appear (mount) on the desktop. You can begin using the
volume right away. If the drive is unformatted, a message will appear on the desktop
saying that the disk is unreadable. You can use OS X’s Disk Utility to easily format
the drive (see section above).
R A X 8 4 0 - I R Q u i c k S t a r t G u i d e A 9 - 8 4 0 - 0 0 0 4 - 1 R E V 1 . 0
- 11 -
Unmount the volume before powering down the unit by dragging the volume’s icon to
the trash bin, or by selecting the volume then pressing Command-E. Disconnecting
the unit without first unmounting the volume can result in data loss.
4.1.4 Creating a Boot Drive
To activate this feature, you must first install OS X on the hard drive in your carrier. The easiest way to do
this is to clone an existing system drive using a utility such as Carbon Copy Cloner or Super Duper. Next,
go to System Preferences Startup Disk. A window will list the available bootable volumes. Select the
volume from which you wish to boot. Another method is to hold down the Option key during boot up. A
screen should appear that allows you to select the volume you wish to use. This is useful if you wish to
boot from your RAX hard drive only some of the time.
4.2 Usage with Windows operating systems
4.2.1 Compatibility
RAX uses 3.5-inch SATA (Serial-ATA) hard drives only. RAX does not require drivers for operation under
Windows XP, Vista, or 7. However, if you install a host card specifically to work with this product, that
card may require drivers. See your card’s User Manual for drivers and instructions.
4.2.2 Formatting a drive
If you purchased your RAX pre-populated with a hard drive, this step should not be necessary unless you
wish to change the format or erase the drive. To format, use the Disk Management utility.
a)
Right-click on My Computer, then select Manage. The Computer Management window will open.
b)
In the left pane of this window, left-click on Disk Management.
c)
The drive should appear in the list of Disks in the lower middle/right pane (see picture below). You
may need to scroll down to see it. If the drive is already formatted, you can identify it easily by its volume
name. If it’s unformatted, the Drive Properties Box will say “Unallocated” and you’ll need to initialize the
disk before formatting it. Initialize the disk by right-clicking the Device Properties Box and selecting
Initialize Disk.
Drive
Properties
Device
Properties
d)
To format the drive, right-click the Drive Properties Box and select Format.