beautypg.com

4 getting started, 1 please note, 2 connection and set-up before first start – Crompton Controls M20 User Manual

Page 8: Getting started, Please note, Connection and set-up before first start, 4getting started

background image

Emotron AB 01-2551-01r4

Getting Started

7

4

Getting Started

4.1

Please note

1. Pay special attention to the safety section in this manual and parts marked

CAUTION.

2. Check that motor/supply voltage corresponds to values on the monitor

product label at the side of the unit.

3. Make a note of the motor’s rated power and full load amps from its name-

plate. Confirm that the current transformer supplied is of the correct size
according to tables 1 and 2 in chapter 6 of this manual.

4.2

Connection and set-up before first start

1. Connect the Emotron M20 according to chapter 5 and Fig. 1.

2. Make sure all safety measures have been taken and switch on the supply

voltage.

3. Use the

key to scroll through the menu. Press and hold the

key and

press the

key to scroll back.

4. Set rated motor power and current in windows 41 and 42. Additional set-

tings to be programmed are discussed in chapter 8.

5. Set monitor function in window 05, overload and underload or only under-

load or only overload. See chapter 12, Parameter list, for range and default
values.

6. Set start delay and response delay in window 31 and 32/34.

7. Compare all set values with the parameter list in chapter 12 to confirm that

all relevant values are set. Advanced features will be found in chapter 9.

NEXT

ENTER

ENTER

NEXT