CONTA-CLIP EMS-Engraver - Manual (Page 6)

3. Connection and assembly of the Engraver to the EMS-2
The connection and assembly of the engraving unit is easy to work through. The
components need careful treatment in order to prevent any damage.
The following describes the assembly process in detail.
3.1 Assembly of the support arm for cable and hose
Place the support bracket on top of the base plate as
shown in the picture and push into the side of the plotter
profile.
Insert the aluminum pipe into the support bracket
Place the support arm into the opposite side, holding the
cable and hose.
3.2 Disassembly of the Pen-holder from the EMS-2
Remove the plastic cover and the safety lock.
Slightly tilt the pen-holder and release
from the holding bar by pulling up.
The unit can be very tight and fixed in the bar.
Remove the pen-holder very carefully to prevent
damaging the holding bar.
5