CONTA-CLIP EMS-Engraver - Manual (Page 2)

1. Adaptation EMS-2 Engraver .........................................................................2
2. Scope of supply................................................................................. ...........3
3. Connection and assembly of the Engraver to the EMS-2.............................5
3.1 Assembly of the support arm for cable and hose ...................................5
3.2 Disassembly of the Pen-holder from the EMS-2 ....................................5
3.3 Installing the Engraving head .................................................................6
3.4 Arrange Vacuum cleaner (EVC) and Controller (EC) .............................6
3.5 Connecting the cables............................................................................7
3.6 Installing the Engraving spindle into the Engraving head ......................7
3.7 Alignment of the Engraving unit .............................................................7
3.8 Connections at the Engraving head .......................................................8
3.9 Placing the cover on the Engraving head ..............................................8
3.10 Test run.................................................................................................8
3.11 Placement of the Engraving material....................................................8
3.12 Buttons and indications of the Engraver-Controller (EC) .....................8
4. Adjustment of the Engraving depth...............................................................9
5. Changing the Engraving needle .................................................................10
6. Engraver-Vacuum-Cleaner (EVC) Bag and Filter change ..........................11
6.1 Changing the Vacuum cleaner bag ......................................................11
6.2 Changing or cleaning of Motor dust-filter..............................................11
7. Instructions for cleaning the Engraving spindle ..........................................11
8. Troubleshooting..........................................................................................12
9. Accessories ................................................................................................13
10. Technical data...........................................................................................14
11. General Safety Rules................................................................................15
11.1 Tool Safety Instructions ......................................................................16
Guide to
adapting the Engraving unit to the EMS-2
Content
1