CIRCUTOR CBS8 (Available until stocks) User Manual
Page 7
----- Relay Station CBS-8 -------- --- Page No. 6
3.- INSTALLATION AND START UP
This manual contains information and warnings that the user
must follow to ensure the safe operation of the equipment and to keep
it in a safe condition. It must not be used until it is finally located on the
electrical board.
If this equipment is used in a way not specified by the
manufacturer, the equipment’s protection may be compromised.
If it is likely that safety has been affected (e.g. visible damage) the power
supply must be disconnected. In this event, contact a qualified service technician.
3.1.- Installing the equipment
Before running voltage through the equipment the following points must be
checked:
a.- Power supply voltage: see label on the side of the equipment.
- Standard power supply: Single phase 230 V
∼
(AC.)
Other voltages: on request
- Frequency
:
50 - 60 Hz
- Power supply tolerance
:
+ 15 % -20%
- Connection board
:
Terminals 1 - 28 (Power supply)
- Consumption
:
4 W