M_n {j> {j?l – CIRCUTOR CVM-NRG96 Series (Available until stocks) User Manual
Page 18

CVM-NRG96
M9817250120-03-05A
18
3. Setting the Power Demand Meter
Magnitude to Integrate
The display shows “
m_n{j^{=i^_” followed by two digits which identify
the code or variable to be integrated as Maximum Demand.
None
**
**
**
**{
{
{
{
Three phase active power
kW III
+0
+0
+0
+0{
{
{
{
Three phase apparent power
kV·A III
-.
-.
-.
-.{
{
{
{
Three phase current
AIII
-0
-0
-0
-0{
{
{
{
Current per phase
A1 - A2 - A3
;
;
;
;'
'
'
'Jb
Jb
Jb
Jb{
{
{
{
The MAX key allows the selection of the Maximum Demand variable to be
integrated.
Once selected to access the next setting step, press
.
Integration Period
The display shows “
m_n{ j^{ J_l” followed by two digits which will
identify the period of integration for the selected magnitude.
{M_n
{J>
{J?l
{{{+/
To write or change the value of the integration period repeatedly press the
MAX key increasing the value of the digit which is flashing at the time.
When the required value is on the screen, move on to the following digit by
pressing MIN, to allow the remaining values to be changed.
When the last digit has been changed, press MIN to move back to the first
digit, allowing the previously set values to be changed again.
The integration period may vary between 1 to 60 minutes.
To enter the data and access the following setting step, press
.