Casella CEL CEL-450 - Manual (Page 54)

5.2 Recall Stored Data
Data stored in the instrument can be recalled to the display for
inspection. This allows the operator to check the quality of results before
leaving the test site.
To display data from any stored run, proceed as follows.
Operation Press Display Shows Comments
1. Start from
the Main
menu
This is the Main menu.
It gives access to further
menus that select:
Measurement Mode,
Measurement Setup,
Calibration Sequence,
Data Recall from Memory,
Instrument Configuration.
2. Select the
Memory
option
or
Move the reverse video
cursor to the required line.
3. Move to
the
Memory
menu
On this menu, “current”
refers to the “current
bandwidth”.
Bandwidth is selected via
the Measure Mode option
as described in Section 3.1.
4. Move to
the list of
run Dates
for the
specified
bandwidth
and select
the
required
date
then
or
This menu shows the dates
on which all runs with the
specified bandwidth were
saved (i.e. a specified
bandwith or all available
bandwidths).
Page 54 - CEL-450/490 Operators Handbook
Operation