Dimension One Spas 01510-1030 - Manual (Page 38)

Sonic Immersion System Dealer Installation Guide
7. Using a 3/8”bit, drill holes in two corners of the rectangle.
Make certain that the holes are within the lines. Using a
center punch to mark the drilling centers will prevent the
drill bit from wandering.
8. Using a saber saw, cut out the rectangular piece from the
panel.
9. Depending on where the hole in the panel is located you may
need to use some Silicone caulking in the panel grooves to
prevent moisture from entering the CD player, see picture
below.
34