Optoma EH415e - Manual (Page 5)

4
Usage Notice
Precautions
Please follow all warnings, precautions and
maintenance as recommended in this user’s
guide.
▀ ■ Warning- Do not look into the projector's lens when the
lamp is on. The bright light may hurt your eyes.
▀ ■ Warning- To reduce the risk of fire or electric shock, do
not expose this projector to rain or moisture.
▀ ■ Warning- Please do not open or disassemble the
projector as this may cause electric shock.
▀ ■ Warning- When replacing the lamp, please allow the unit
to cool down. Follow instructions as described
on page 67.
▀ ■ Warning- This projector will detect the life of the lamp
itself. Please be sure to change the lamp when it
shows warning messages.
▀ ■ Warning- Reset the "Lamp Reset" function from the
on-screen display "System|Lamp Setting" menu
after replacing the lamp module
(refer to pages 51-52).
▀ ■ Warning- When switching the projector off, please ensure
the cooling cycle has been completed before
disconnecting power. Allow 90 seconds for the
projector to cool down.
▀ ■ Warning- Do not use lens cap when projector is in opera-
tion.
▀ ■ Warning- When the lamp is approaching to the end of its
life time, the message "Replacement suggested"
will show on the screen.
Please contact your local reseller or service cen-
ter to change the lamp as soon as possible.
N
ote
N
ote
When the lamp reaches
the end of its life, the
projector will not turn
back on until the lamp
module has been
replaced. To replace
the lamp, follow the
procedures listed under
"Replacing the Lamp"
section on page 67.