Subaru 2011 Tribeca - Manual (Page 396)

Black plate (241,1)
北米Model "A3160BE-C" EDITED: 2010/ 11/ 19
3. Press and hold the hand-held trans-
mitter button. The HomeLink
® indicator
light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
The programming for the previous device
is now erased and the new device can be
operated by pushing the HomeLink
®
button.
& Erasing HomeLink ® button
memory
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink
® buttons be
erased for security purposes.
1. Press and hold the two outside buttons
until the indicator light begins to flash
(after 20 seconds).
2. Release both buttons.
& In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink
® button after
programming, contact HomeLink at
www.homelink.com or call 1-800-355-
3515 for assistance.
Rear view camera (if
equipped)
A rear view camera is attached to the rear
gate. When the ignition switch is
“ON” and
the select lever is set to “R”, the rear view
camera automatically displays the rear
view image behind the vehicle on the
navigation monitor or on the inside mirror.
WARNING
. Since the rear view camera uses
a wide-angle lens, the image on
the monitor is different from the
actual view in terms of distance.
. Since the range of the image on
the monitor is limited, you should
always check the rear view and
Interior equipment
6-21
– CONTINUED –
6