Function settings – Subaru 2011 Tribeca User Manual
Page 184

Black plate (25,1)
北米Model "A3160BE-C" EDITED: 2010/ 11/ 19
Function settings
A SUBARU dealer can change the settings of the functions shown in the following table to meet your personal requirements. Contact
the nearest SUBARU dealer for details. If your vehicle is equipped with the genuine SUBARU navigation system, the settings for some
of these functions can be changed using the navigation monitor. For details, please refer to the Owner
’s Manual supplement for the
navigation system.
Item
Function
Possible settings
Default setting
Page
Alarm system
Alarm system
Operation/Non-operation
Operation
2-16
Monitoring start delay time (after closure of doors) 0 second/30 seconds
30 seconds
2-17
Impact sensor operation (only models with shock
sensors (dealer option))
Operation/Non-operation
Non-operation
2-20
Passive arming
Operation/Non-operation
Non-operation
2-19
Dome light/map lights illumination
ON/OFF
OFF
2-16
Remote keyless entry sys-
tem
Hazard warning flasher
Operation/Non-operation
Operation
2-8
Audible signal
Operation/Non-operation
Operation
2-11
Key lock-in prevention
Key lock-in prevention
Operation/Non-operation
Operation
2-7
Remote engine start system
(dealer option)
Horn chirp confirmation
ON/OFF
ON
7-10
Rear window defogger
Rear window defogger
Operation for 15 minutes/
Continuous operation
Operation for 15 minutes 3-36
Windshield wiper deicer
Windshield wiper deicer
Operation for 15 minutes/
Continuous operation
Operation for 15 minutes 3-35
Map lights/Dome light
Operation of map lights/dome light OFF delay
timer
OFF/Short/Normal/Long
Normal
6-2/6-3
Map lights
Illumination in conjunction with a door open
Operation/Non-operation
Operation
(Illumination - ON)
6-3
Battery drainage prevention
function
Battery drainage prevention function
Operation/Non-operation
Operation
2-6
23
– CONTINUED –
0