Subaru 2011 Tribeca - Manual (Page 13)

11
Getting Started
Instrument
Panel
Gauges
Personalize
Contr
ols
While
Operating
Safety / In Case
of Emergency
Additional Information
Contr
ols
Windshield Wipers
To turn wipers on, press the wiper
control lever down one level for
intermittent, two levels for low, or three
levels for high speed. Return the lever
to the “OFF” position to stop wipers.
For a single wipe/mist, pull the lever
toward you. To spray washer fluid
spray, press the washer button at the
end of the wiper control lever.
To operate the rear wiper, turn the
knob on the end of the control lever
forward to intermittent, continuous,
or wash position. Turn the end of the
lever backward for wash operation
when the rear wiper is not in use.
When the automatic transmission is
placed in reverse, the rear wiper will
operate continuously even when the
rear wiper is in the “INT” position.
Daytime Running Lights
Daytime running lights are standard
on your vehicle. A reduced brightness
high beam will be automatically turned
on by the daytime running light system
when the engine has started and the
parking brake is fully released or the
light switch is in the “OFF” or “
”
position. You must always switch on
your headlights when it’s dark outside
by turning the light switch to the
“
” position.
Windshield Wiper De-Icer
Remove the snow from
your windshield before
starting this system.
To begin de-icing,
push the button (the light will illuminate
while in operation). The de-icing
system automatically shuts off after
about 15 minutes. If more time is
required, push the button to reactivate
the de-icer.
1
2
3
INT.
LOW
HIGH
OFF
782335_11_Tribeca_QRG_102010b.indd 11 10/20/10 3:10 PM