Subaru 2011 Tribeca - Manual (Page 210)

Black plate (53,1)
北米Model "A3160BE-C" EDITED: 2010/ 11/ 19
2. Pull out the seatbelt slowly from the
overhead retractor.
3. After confirming that the webbing is not
twisted, insert the connector (tongue)
attached at the webbing end into the
buckle on the right-hand side until a click
is heard. Make sure that the “ ” mark on
the connector (tongue) and the “ ” mark
on the buckle are aligned.
If the belt stops before reaching the
buckle, return the belt slightly and pull it
out more slowly. If the belt still cannot be
unlocked, let the belt retract slightly after
giving it a strong pull, then pull it out slowly
again.
4. Insert the center seatbelt tongue plate
in the center seatbelt buckle marked
“CENTER” on the left-hand side until it
clicks.
5. To make the lap part tight, pull up on
the shoulder belt. And place the lap belt as
low as possible on your hips, not on your
waist.
! Unfastening the seatbelt
Seat, seatbelt and SRS airbags
1-25
– CONTINUED –
1