Subaru 2011 Tribeca User Manual
Page 395
Black plate (240,1)
北米Model "A3160BE-C" EDITED: 2010/ 11/ 19
6-20
Interior equipment
trol System and your garage door opener
should activate when the HomeLink
®
button is pressed.
& Programming for entrance
gates and garage door open-
ers in Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
2. Press and hold the two outside buttons
until the HomeLink
®
indicator light begins
to flash (after 20 seconds). Release both
buttons.
NOTE
If any of the HomeLink
®
buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
3. Hold the end of the entrance gate
’s/
garage door opener
’s hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
®
buttons on
the driver
’s sun visor, keeping the indica-
tor light in view.
4. P r e s s
a n d
h o l d
t h e
d e s i r e d
HomeLink
®
button.
5. Press and release (
“cycle”) the hand-
held transmitter button every 2 seconds
until step 6 is complete.
6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door
opener by pressing the programmed
HomeLink
®
button.
& Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink at www.homelink.com
or call 1-800-355-3515.
& Operating the HomeLink
®
Wireless Control System
Once programmed, the HomeLink
®
Wire-
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
& Reprogramming a single
HomeLink
®
button
1. Press and hold the HomeLink
®
button
you wish to reprogram. DO NOT release
the button until step 4 has been com-
pleted.
2. When the HomeLink
®
indicator light
begins to flash slowly (after 20 seconds),
position the hand-held transmitter of the
device for which you wish to program the
button at 1 to 3 inches (25 to 76 mm) away
from the HomeLink
®
button surface.