Subaru 2011 Tribeca - Manual (Page 373)

Black plate (216,1)
北米Model "A3160BE-C" EDITED: 2010/ 11/ 19
5-28
Audio
Auxiliary input jack
By connecting a commercial audio pro-
duct to the vehicle, such as a portable
audio player, you can hear its sound via
the vehicle
’s speaker.
An auxiliary (AUX) input jack is equipped
in the lower compartment of the center
console. A stereo mini pin plug (3.5ø) can
be inserted in this jack. The connection
cable is available at electrical appliance or
similar stores.
To use the AUX input jack:
1. Connect a portable audio player to the
AUX input jack.
2. Press the
“RSE AUX” button on the
audio control panel to turn on the auxiliary
audio input.
3. Play back the portable audio player.
Refer to the Owner
’s Manual for the
portable audio player.
NOTE
. The output sound of the portable
audio player is not loud, and the sound
via the vehicle
’s speakers that are
connected to the vehicle audio set
may be very low. If you turn up the
volume of the audio set, the volume
becomes louder. However, when you
change from one portable audio player
to another one, the volume levels via
the vehicle
’s speakers may be signifi-
cantly louder compared to the prior
device. To avoid a large volume differ-
ence, turn down the volume when you
change be tween portable a udio
players.
. In some cases, when the sound
volume of the portable audio player is
low, the sound becomes bad when you
turn up the volume of the vehicle audio
system. In this case, adjust the sound
volume of the portable audio player.
. In some cases, noise occurs be-
cause of a bad connection between the
portable player and the vehicle audio
system. Try cleaning the stereo jack
and audio plug.
. If noise is not reduced, check for
disconnection of the cord or malfunc-
tions of the portable player.