Altera Transceiver Signal Integrity - Manual (Page 33)

December 2011 Altera Corporation Transceiver Signal Integrity Development Kit,
Stratix IV GX Edition User Guide
Additional Information
This chapter provides additional information about the document and Altera.
Revision History
The following table displays the revision history for this user guide.
To locate the most up-to-date information about Altera products, refer to the
following table.
Date Version Changes Made
December 2011 2.1
■ Removed content about the kit CD ROM. CD ROM is no longer included in the kit.
■ Add notes about installing Quartus II to make sure needed files are present to run the
demonstration application.
■ Made changes because of the dual-die flash to single-die flash replacement.
■ Add further content explaining how to use configuration jumper J62.
December 2009 2.0
■ Added a third test design (signal_integrity_demo3.sof) and two new tabs to control it.
signal_integrity_demo3.sof is only available for the production silicon version of the board.
■ Moved power and temperature information to a separate tab.
■ Changed directory path name from stratixIVGX_4sgx230es_si to stratixIVGX_4sgx230_si.
■ Changed flash programming .sof name from stratixIVGX_4sgx230es_si_flash_prog.sof to
s4gx230_si_bup.sof.
February 2009 1.0 Initial release.
Contact (1) Contact Method Address
Technical support Website www.altera.com/support
Technical training
Website www.altera.com/training
Email [email protected]
Product literature Website www.altera.com/literature
Nontechnical support (general) Email [email protected]
(software licensing) Email [email protected]
Note to Table:
(1) You can also contact your local Altera sales office or sales representative.