Altera Cyclone V E FPGA - Manual (Page 7)

December 2014 Altera Corporation Cyclone V E FPGA Development Kit
User Guide
2. Getting Started
The remaining chapters in this user guide lead you through the following
Cyclone V E
FPGA development board setup steps:
■ Inspecting the contents of the kit
■ Installing the design and kit software
■ Setting up, powering up, and verifying correct operation of the FPGA
development board
■ Configuring the Cyclone V E FPGA
■ Running the Board Test System designs
f
For complete information about the FPGA development board, refer to the
Cyclone V E FPGA Development Board Reference Manual .
Before You Begin
Before using the kit or installing the software, check the kit contents and inspect the
board to verify that you received all of the items listed in
“Kit Features” on page 1–1 .
If any of the items are missing, contact Altera before you proceed.
Inspect the Board
Perform these steps:
1. Place the board on an anti-static surface and inspect it to ensure that it has not been
damaged during shipment.
c Without proper anti-static handling, you can damage the board.
2. Verify that all components on the board appears in place and intact.
1 In typical applications with the Cyclone V E FPGA development board, a heat sink is
not necessary. However, under extreme conditions, the board might require
additional cooling to stay within operating temperature guidelines. The board has
two holes near the FPGA that accommodate many different heat sinks, including the
Dynatron V31G. You can perform power consumption and thermal modeling to
determine whether your application requires additional cooling.
For information
about measuring board and FPGA power in real time, refer to “The Power Monitor”
on page 6–10 .
f
For more information about power consumption and thermal modeling,
refer to
AN 358: Thermal Management for FPGAs .