Altera OCT - Manual (Page 2)

Parameter Settings
This section describes the Altera OCT megafunction parameter settings. You can parameterize the
megafunction using the MegaWizard Plug-In Manager.
Table 1: Altera OCT MegaWizard Plug-In Manager Page Options and Description
Description Configuration Setting MegaWizard
Plug-in Man-
ager Page
Select from the following options:
• Create a new custom megafunction
variation
• Edit an existing custom megafunction
variation
• Copy an existing custom megafunction
variation
Which action do you want to perform? 1
Select Altera OCT from the I/O category. Select a megafunction from the list below
2a
Specify the device family that you want to
use. Which device family will you be using?
Choose Verilog HDL (.v) as the output file
type. Which type of output file do you want to create?
Specify the name of the output file. What name do you want for the output file?
Turn on this option if you want to return
to this page to create multiple
megafunctions. Return to this page for another create operation
Defines the OCT calibration mode. Select
from the following options:
• Single: For a given voltage, the OCT
block can generate calibration code only
for a single pair of series/parallel
termination values.
• Double: For a given voltage, the OCT
block can generate calibration code for
up to two pairs of series/parallel
termination values.
• POD: Configures the OCT block to
generate calibration code specific for
pseudo-open drain (POD) I/O
standards.
Calibration mode 3
Altera OCT Megafunction User Guide Altera Corporation
Feedback
ug-altera_oct
Parameter Settings 2
2013.11.29