DirecTV HR10-250 - Manual (Page 42)

32
C h a p t e r 2 G u i d e d S e t u p
or high-definition video signals. You must connect your HD DVR to your HDTV using
the HDMI cable, the HDMI-to-DVI cable, or the Component Video cable to use the
enhanced- or high-definition video output formats.
The table below shows which video output formats can be viewed with each of the HD
DVR’s video output jacks.
Next Steps. Once you have chosen your default video settings, you are ready to begin the
last part of Guided Setup. Go to “Phone Setup” on page 33.
Video Output Format Composite A/V S-Video Component HDMI
480i standard-definition
interlaced
OK OK OK OK
480p enhanced-definition
progressive
no picture no picture OK OK
720p high-definition
progressive
no picture no picture OK OK
1080i high-definition
interlaced
no picture no picture OK OK
While a cable is connected to the
HDMI Output jack, the Component
Video Output is disabled. You can’t view
video from both the HDMI Output and the
Component Video Output at the same
time.