Fluke 725 - Manual (Page 21)

Getting Acquainted with the Calibrator
11
Table 4. Key Functions
No Name Description
A O
Turns the power on or off.
B l
Selects voltage, mA or Loop Power measurement function in the upper display.
C A
Selects the pressure measurement function in the upper display. Repeated pushes cycle
through the different pressure units.
D K
Zeros the pressure module reading. This applies to both upper and lower displays.
E C
Turns backlight on or off. Turns Contrast Adjust mode on when powering up.
F F
Toggles frequency and ohms measurement and sourcing functions.
G D
Toggles between Centigrade or Fahrenheit when in TC or RTD functions.
H G
Recalls from memory a source value corresponding to 100 % of span and sets it as the
source value. Press and hold to store the source value as the 100 % value.
I H
Increments output by 25 % of span.
J I
Decrements output by 25 % of span.
K J
Recalls from memory a source value corresponding to 0 % of span and sets it as the
source value. Press and hold to store the source value as the 0 % value.
Identifies Firmware version. Press and hold
J when powering up.