Woodhaven 1826: Drill Press Table - Manual (Page 2)

On each of the 1-1/2" bolts (HB050), install a square
washer (1826C), a 1" washer (WFN002), a lock washer
(WL001) and a nut (NUT015). Insert the head of two bolts (one
at a time) up thru the front two slots in your drill press table and
slide the Ultra Tracks connected to the Woodhaven drill press
table on to the bolt heads. Repeat for the back two slots.
Note: If the bolt heads won't fit thru the slots in your drill
press table, you will have to assemble the hardware on the
bolt after you've inserted the bolt thru the slot. Adjust the
Woodhaven drill press table so it's centered left-to-right and
front-to-back (or where desired) on your drill press and tighten
the nuts. See fig. 2.
ACCESSORIES
The Drill Press Fence (1827 or 1827XL) and Flip Stops
(4512 or 4514) increase your speed and efficiency when drilling
multiple parts.
The Toggle Clamp Kit (1826T) provides 500 lbs. of clamp-
ing force and the Drill Press Table has two slots for up to two of
these clamps to be used. See fig. at right
©Copyright WOODHAVEN INC. 9/7/07
(800) 344-6657 or WWW.WOODHAVEN.COM
2
1827XL
4512
1826T
HB050
1826C
WFN002
WL001
NUT015