Woodhaven 1826: Drill Press Table - Manual

1826
Drill Press Table
Please Read Carefully!
1
BEFORE BEGINNING
Identify and verify that you have all the parts listed. Read
the instructions at least once, familiarizing yourself with the
parts and assembly instructions before beginning. You’ll need a
#3 Phillips screwdriver and a 7/16" wrench for assembly.
ASSEMBLY
Insert a 1" screw (MF015) thru the four countersunk holes
in the drill press table (1826A), place the table upside down on
a flat surface and start an oval nut (5760B - raised side first)
on the end of the screws. Slide a 8" Ultra Track (4408) on two
oval nuts until it's centered end-to-end on the oval nuts and the
face of the Ultra Track is flush with the edge of the drill insert
(1826B) opening, then tighten the screws. See fig. 1 & upper
inset photo.
Install two 1" washers (WFN002) on each 3/4" bolt
(HB020), insert the bolts thru the holes in the leveler (1826D)
and start an oval nut (5760B - raised side first) on the bolt ends.
Install the levelers on the Ultra Track by inserting the
oval nuts into the T-slot of the track. Position the levelers over
the drill insert, with the edge of the levelers resting against the
underside of the drill insert, tighten the bolts.
See fig. 1 & lower inset.
Parts List:
Part Description Quantity
1826A Drill Press Table . . . . . . . . . . . . . . . . . . . . . . . 1
1826B Drill Insert . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
1826C Square Washer . . . . . . . . . . . . . . . . . . . . . . . . 4
1826D Leveler . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
4408 8” Ultra Track . . . . . . . . . . . . . . . . . . . . . . . . . 2
NUT015 Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
HB050 1-1/2" Bolt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
HB020 3/4" Bolt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
MF015 1" Screw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
WFN002 1" Washer . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
5760B Oval Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
WL001 Lock washer . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
1826D
4408
4408
1826D