Woodhaven 966D: Domino Add-on Kit - Manual (Page 2)

Install the existing 1" screws (MF015) you removed from
the MDF Base earlier, insert them thru the countersunk holes in
the Domino Fence (966E2) and start existing oval nuts (5760B)
on the ends of the screws. Slide the Domino Fence on to the
T-slot in the front of the Fence Bracket until it butts against the
"L" cutout in the Domino Guide and tighten the screws. See
fig. 3.
Install an existing washer (WB002) on the 3/4" screw
(5771B), insert the screw thru the hole in the Domino Fence
and start an oval nut on the end of the screw. Slide the 6" fence
(4006) on to each oval nut until it butts against the "L" cutout in
the Domino Guide and tighten the screw. See fig. 3.
Clamp the MDF Base to a bench so it overhangs enough to
provide access to the four screws in the underside. Loosen the
four screws, place your Domino machine between the Domino
Guides and clamp a straight edge to both 6" fences. Lightly
squeeze the two Domino Guides together (with the Domino
machine between them) and tighten the screws.
Follow the directions that came with your 966 Biscuit
Master as far as how to use this.
©Copyright WOODHAVEN INC. 9/15/07
(800) 344-6657 or WWW.WOODHAVEN.COM
3
3 4
966E2
Domino
Fence