Woodhaven 3010: Rail Kit - Manual (Page 2)

ASSEMBLY
Install a 1-1/4" screw (MF020) thru the countersunk
holes in each of the 48" Fence Rails & Base Rails (3010A
& 3010B) and start an oval nut (5760B - smooth side
first) on the end of each screw. Slide four 1-7/8" Double
Tracks (4002) on to the oval nuts on each Fence Rail.
Slide the 1-7/8" Double Tracks attached to the
Fence Rail on to the oval nuts of the Base Rail so that
the face of the Fence Rail is flush with the edge of the
Base Rail. Check that the ends of the Fence & Base Rail
are flush to each other and tighten the screws. These two
assemblies will be referred to as the Rails. See fig. 1
Slide the 48" Double Track (4048) on to the remaining oval
nuts on each Fence Rail. Position the track so it's 1/4" below
the top edge of the Fence Rail, using the 1/4" shims (3010E) as
a spacer, flush with the ends and tighten the screws. See fig. 1
MF020 x 12
5760B x 12
3010A
3010B
4048
4002
1
1
2
Install a washer (WB001) on each 1/2" screw (MT010),
insert a screw thru only one of the two holes in each angle brack-
et (CAB010) and start an oval nut (5750B - smooth side first) on
the end of each screw. Slide the oval nut in a T-slot in the face
of each of the 2-1/4" Double Tracks (3010D). Position the angle
bracket so it's flush to the end of each track and so there are two
mirror assemblies. When done, tighten the screws. These four
assemblies will be referred to as the Work Supports.
See fig. 2
Install three 3/8" spacers (BUSH050) on each of the four
knobs (5550S). Starting at 6" in from each end of the Rail, there
are 1/4" holes located every 4" along it's length. From the outside
of the Rail, insert the stud of the knob thru a hole that is near to,
but not past, each end of the work. Start an oval nut (5760B -
smooth side first) on the end of each knob. The two remaining
holes near each end of the Rail are for the 3020 Connector Kit
only.
Slide a Work Support over each of the oval nuts, with the
flat end of the angle bracket oriented upwards. The pair of Work
Supports/angle brackets on each Rail can face towards each
other, or away from each other, whatever suits you for access.
Tighten the Work Supports using the knobs.
5550S
BUSH050 x 3
5760B
Work
Supports
X4
MT010
WB002
CAB010
5760B
3010D
Work
Supports