New pic – Woodhaven 6002-6004: Horizontal Router Table with Angle-Ease User Manual

Page 3

6000S Side - Top

4009 Track

4006 Track

6000S Side

- Bottom

Bottom of Plate

Top of Plate

MF015 & 6000G

5859, WS002 & 5760B

Top of Plate

Bit tilts UP

Top of Plate

Bit tilts DOWN

Bottom of Plate

BEFORE BEGINNING

Identify and verify that you have all the parts

listed. Read the instructions at least once, familiarizing
yourself with the parts, before beginning. You’ll need a #3
Phillips screwdriver and a 7/16" wrench for assembly.

ANGLE-EASE ASSEMBLY
Assemble

the

Angle-Ease

(1470X) according to the

instructions that are included with it and set it aside for now.

ATTACH PLATE & TRACKS

The router plate (6000PA) can be mounted in one of

two ways. If the bit opening in the router plate is placed at
the top, the router will tilt down and the bit will tilt up. If
you place the bit opening in the router plate at the bottom,
the router will tilt up and the bit will tilt down. Decide
which way you want to tilt the router/bit. See fig. 1 & 2.

On two ratchet handles (5859), insert a washer

(WS002) on the stud, insert the studs thru the top two
corners of the router plate and start an oval nut (5760B -
smooth side first) on the ends of the studs. See fig. 1.

Install four 1" screws (MF015) thru the four countersunk

holes in the router plate and start a track guide (6000G -
chamfered side first) on the ends of the screws. The hole gets
tighter as you tighten the screw in the track guide, reducing
any chance of vibration loosening the screw. See fig. 1.

Slide a 24" Double Track (4024) on the oval nut

and two track guides on each short side of the router
plate. Position the Double Tracks so the 1-1/2" wide
smooth sides are facing each other and the T-slot sides
are facing out away from each other. See fig. 1 & 2.

The rib on each side of the router plate should be

in the T-slot of the track. Loosely snug all four 1" screws
until the track won't slide, then loosen the screws until
it slides smoothly but not loosely. There should be some
tension on the track. Center the router plate on the Double
Tracks and tighten the ratchet handles. See fig. 2.

ATTACH SIDES & TRACKS

Install a washer (WS002) on the sixteen 1-1/4" bolts

(HB040). Insert the bolts thru the holes shown in the pair of
phenolic sides (6000S) and start an oval nut (5760B - smooth
side first) on the ends of the bolts. The sides should look like
mirror images of each other when done. See fig. 3 & 8.

Slide a 9-1/4" Double Track (4009) and a 6" Double

Track (4006) onto the oval nuts located near the long
edges of each side. Position the tracks even with the end
and edges of each side and tighten the bolts. See fig. 3.

Lay the 24" Double Tracks/Router Plate on a flat

surface and slide the two sides/oval nuts at the back
of the sides on to the two tracks. Square the tracks
to the sides, adjust the tracks flush to the bottom of
the sides and tighten the four bolts. See fig. 4.

Bottom of Plate

Top of Plate

Smooth 1-1/2” wide faces of

Double Tracks should be facing

inside towards each other.

NEW PIC

Part# Description Qty.
MF037 5/8"

Screw 2