New pic – Woodhaven 6002-6004: Horizontal Router Table with Angle-Ease User Manual

Page 2

INSTALL CRANK HANDLE, ETC.

Get the crank handle (6000C). There are two assemblies

to this part - one has a crank & nut, the other has a bolt,
and both have a mounting bracket with two holes. Attach
the bolt to the back top of the router plate with two
1/2" screws (5770B) thru the two holes in its mounting
bracket, but leave them loose for now. See fig. 10.

Install the crank assembly on the back of the crank

support (6000B - the side with the machined ends) using
two 1/2" screws (5770B) thru the two holes in its mounting
bracket, but leave them loose for now. See fig. 10.

From the front of the support, insert a washer (WS002)

on each stud of the ratchet handle (5859), insert the stud thru
the hole at each end and start an oval nut (5760B - smooth
side first) on the end of the studs. See fig. 10 & 11.

Slide the support/oval nuts onto the 24" tracks until

the nut of the crank lines up with the bolt on the plate.
Turn the crank to screw the nut onto the bolt approximately
1", then tighten the ratchet handles on the crank support
and the four 1/2" screws (5770B). See fig 10 & 11.

ATTACH ANGLE-EASE, ROUTER & GUARD

Assemble and mount the Angle-Ease (1470X) to the

router plate following the instructions provided with it. After
completing that, mount your router in the Angle-Ease. Insert
the two thumb screws (5503) through the slots of the Guard
(224) and into the threaded holes in the router plate (6000PA).

MOUNT ZERO-CLEARANCE INSERT

Mount a zero-clearance insert (6000N) in the recessed

opening in the table using two 3/4" screws (MF010). An extra
insert is provided and extras may be ordered. See fig. 12.

USING THE HORIZONTAL ROUTER TABLE

The crank provides 1-3/8" of fine bit height adjustment.

By loosening the two ratchet handles on the crank support,
you can move the entire router plate/crank support assembly
up or down for a great range of coarse adjustment.

Make sure the two handles on the router plate are

loosened and the two handles on the crank support are tight
before attempting to turn the crank. Make sure you tighten
the router plate handles after all height adjustments.

Clamp or bolt the horizontal table to a workbench before

using. The horizontal table can be used for mortising, edge
routing, vertical panel bits, cutting tenons, etc. For safety, we
recommend the bit be kept under the work/table during use.

For mortising, we recommend our optional 6010 or 6011

Mortising Table. For additional safety and routing consistency
we recommend using the 6000 Hold-All Kit we include.

There is an extra set of mounting holes in the Phenolic

Sides (6000S) which allow you to elevate the 9-1/4"
Double Tracks/Table 3/4". This extra table height may be
necessary depending on the how you have the Angle-Ease
mounted. There are optional 9-1/4" Ultra Tracks (4009 - two
required) available that will elevate the table 2-5/8".

(800) 344-6657 or WWW.WOODHAVEN.COM

NEW PIC

P
M

Attach crank assembly

to 6000B Crank
Support w/1/2” screws.

Attach bolt assembly

to Router Plate
w/1/2” screws.

Attach 6000B

Crank Support
to 24” tracks w/
ratchet handles.