Reflash computer – Vortech 2007-2009 FORD GT500 OEM POWER PACK UPGRADE User Manual

Page 20

DP/N: 007125v1.0

27AUG2010 GT500 OEM POWER PACK

Fig. 6-a

SELECT

ARROW KEYS

IMPORTANT! To ensure trouble-free programming of your vehicle's computer:

• Make sure the vehicle's battery is sufficiently charged.

• Turn off all accessories and close doors to prevent unnecessary drain on the battery.

• Do not attempt to program your vehicle while a battery charger is connected.

• Improper battery voltage will result in failure of the programming process.

• Do not disconnect the cable or turn off the ignition during programming.

Reconnect the battery if previously dis-

connected.

Locate the vehicle’s OBD2 connector

located under the dash on the driver side

of the vehicle. (See Fig 6-b)

Attach the OBD2 connector from the

reflash tool that is provided in the kit to

the vehicle’s OBD2 port. Make sure this

connector is seated all the way in the

vehicle’s OBD2 port. Do not allow this

connector to become disconnected dur-

ing programming or damage may occur

to the vehicle’s ECM. (See Fig 6-c)

6. REFLASH COMPUTER

CANCEL

NOTE: • All vehicles equipped that have aftermarket ste-

reos will experience problems with the ability to

re-program the vehicle’s ECM. It is necessary to

disconnect the aftermarket stereo from the facto-

ry wiring harness before continuing with the pro-

gramming procedure.

• Do not disturb the cable or turn the ignition off

during this time. If the programming is disrupted,

the computer will not start or run your vehicle!

Fig 6-b

Fig 6-c

OBD-II

CONNECTOR