Power pack cai installation, cont'd – Vortech 2007-2009 FORD GT500 OEM POWER PACK UPGRADE User Manual

Page 19

DP/N: 007125v1.0

27AUG2010 GT500 OEM POWER PACK

POWER PACK CAI INSTALLATION, CONT'D

Assemble the carbon fiber intake tube with the

supplied hose couplers. Lubricate the inside of the

coupler on the filter side to aid in sliding over from

the intake tube and onto the MAF housing. This

coupler will need to be installed all the way onto

the carbon fiber intake tube until it is flush. (See

Figure 5-h)

Slide the intake tube coupler onto the throttle

body until it seats and tighten both hose clamps.

(See Figure 5-g)

With both clamps loose on the filter side, support

the filter with one hand and slide the coupler from

the intake tube over onto the MAF housing.

Re-aligning the housing and intake tube as you

slide the coupler will assist in engaging the cou-

pler to the housing. (See Figure 5-i).

Once the entire intake tube assembly is posi-

tioned properly (ensure the MAF is positioned out-

side heat shield as shown) and with adequate

clearance, then tighten all the hose clamps. (See

Figure 5-j)

Connect the MAF wiring harness.

Re-attach the breather hose.

Re-connect the bypass valve vacuum hose.

Fig. 5-g

Fig. 5-h

Fig. 5-i

NOTE:

Using a light coat of clean engine oil will help

the couplers slide over the beads.

Fig. 5-j