New supercharger pulley installation – Vortech 2007-2009 FORD GT500 OEM POWER PACK UPGRADE User Manual
Page 10
DP/N: 007125v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
27AUG2010 GT500 OEM POWER PACK
5
A.
Once the OEM pulley has been removed, remove
the tool from the pulley and shaft. Reconfigure the
tool as shown to install the new pulley. Ensure
that the free rolling face of the thrust bearing is
facing the flanged nut, and not the pulley and
washer. (See Figure 2-a)
B.
If needed, apply more lubricant to the threads of
the 5/8” screw and the bearing.
C.
Insert the tool through the new pulley as shown
D.
Thread the install tool into the center threaded
hole of the supercharger until the 5/8” screw seats
against the supercharger shaft. (See Figure 2-b &
2-c)
2.
NEW SUPERCHARGER PULLEY INSTALLATION
Fig. 2-a
Fig. 2-b
Fig. 2-c (pulley shown installed for clarity)