Power pack cai installation – Vortech 2007-2009 FORD GT500 OEM POWER PACK UPGRADE User Manual

Page 17

DP/N: 007125v1.0

27AUG2010 GT500 OEM POWER PACK

POWER PACK CAI INSTALLATION

Locate the supplied vacuum hose. Using a utility

knife, cut a slit on one side of the hose the entire

length. A box cutter works best when the blade is

only exposed to cut half the hose diameter. Using

a vise to hold the utility knife in place, while run-

ning the hose over it in short lengths works best.

Use the hose parting line to ensure you cut a

straight line.

Attach the vacuum hose to the heat shield as

shown. (See Figure 5-a) Trim the excess hose off.

Use the remainder hose to attach to the lower

portion of the heat shield as shown. (See Figure

5-e) This will ensure the heat shield does not rub

through the A/C lines below where it will be posi-

tioned. (See Figure 5-b)

Install the heat shield as shown and secure it with

the hardware from the OEM air box and the hard-

ware used to secure the ABS bracket from a pre-

vious step. (See Figure 5-c)

Fig. 5-a

Fig. 5-b

Fig. 5-c