Vortech 1986-1993 Ford 5.0 Mustang User Manual

Page 24

P/N: 4FA020-010

16APR09 v4.1(86-93 5.0 Mus (4FA v4.1))

G. Clamp the provided rubber cap onto the vent fitting on

the throttle body.

h. With the 3/8” rubber hose, route blowby to the air filter

cover through the inline filter provided.

I. 1986-93 RENEGADE 5.0L KIT ONLY:

Install the supplied 4” aluminum elbow onto the

supercharger inlet using the silicone sleeve and #64

clamps. The inlet elbow is supplied with cast-in bosses

that can be drilled and threaded for a valve cover breather

fitting (Note: The engine valve cover vent MUST be

properly baffled or else the supercharger may pull in

oil from the engine). The aluminum elbow can then be

attached to the vehicles’ MAF and air inlet filter. Vehicles

equipped with an Anderson Power Pipe can be easily

adapted to the Vortech inlet elbow by using the supplied

4” silicone sleeve and #64 clamps.

J. S.H.O. V-7 KITS ONLY: INNER FENDER AIR INLET KIT

1. Thread the supplied 3/8 x 90" x 1/4 NPT fitting into

the 4" aluminum inlet elbow.

2. Install the elbow onto the supercharger inlet using

the supplied silicone sleeve and #64 clamps.

3. Route the supplied 3/8" blowby hose from the valve

cover to the supercharger inlet elbow fitting and trim

if necessary. (Note: The engine valve cover vent

MUST be properly baffled or else the supercharger

may pull in oil from the engine).

4. Cut out the Vortech provided template. Using the

template, mark and drill the hole patterm into the

fender apron.

5. Remove the round plastic cover at the rear of the

oval opening on the inner fender.

6. Remove the plastic fender lining from the right

fender.

7. Attach the filter to the mass air flow (MAF) sensor

and secure with the clamp. Place the MAF in the

fender from the outside and secure with fasteners

provided from the engine compartment side.

8. Attach the short sleeve to the MAF and slip one of

the elbows inside the sleeve facing rearward (see

diagram).

9. Connect the 3" long sleeve to the rearward facing

elbow. Slip the second elbow through the round hole

to the engine compartment and secure into the 3"

sleeve.

13. AIR FILTER ASSEMBLY (skip to step I for Renegade applications)

cont'd.

NOTE: If kit is a High Output or Cobra model refer to step

16, and Step J for S.H.O. applications.

Fig. 13-b

Front View

Fig. 13-c

Right Side View