SurgeX SX-AX20 - Manual (Page 16)

SX-AX15 (20) Setup and Control Utility User Manual
Page 15
V. Tabs
(continued)
Outlets
The Outlets tab is used to configure all 8 of the Axess outlets.
Select Outlet: This combo box allows for
selection of the outlet to be configured. It is
initially populated with the default outlet
names, but is populated with the user
defined names as they are entered. The
outlet names are always displayed in outlet
order (1-8).
Name: This field is used to define the name
of the selected outlet. This name will appear
on the Axess web page and CLI. It will
accept all printable
characters. The
maximum length of a name is 20 characters.
Initial State: This combo box is used to set
the startup state of the selected outlet. This
setting is used on cold boots only. Warm
rebooting has no effect on the outlet state.
Groups
The Groups tab is used to add, delete and edit outlet
groups.
Select Group: This combo box is used to
add, delete, or select a group to be edited.
To add a group, select “Add Group” from the
combo box. This will create a new group with
the name NewGroupn, where n is the
group’s internal ID number. To delete a
group, select the group to be deleted using
the combo box. Then select Delete Group
from the combo box. A confirmation dialog
will be displayed to prevent accidentally
deleting a group. To edit a group, select the
group to be edited using the combo box.
Name: This field is used to edit the name of
the selected group. The group name can be
made up of any printable character, and may
be up to 20 characters in length.
Outlets: This button will display the Select
Outlets dialog box. Use this dialog box to select the outlets that will belong to this group.