SurgeX SX-AX20 - Manual (Page 15)

SX-AX15 (20) Setup and Control Utility User Manual
Page 14
V. Tabs
Tabs
The following outlines all of the tabs and the elements that will be displayed in the associated
panes.
Device
The Device tab is used to set up the general
information about the device.
Name: This field is used to set the name of
the Axess. It will accept all printable
characters. The maximum length of the
name is 20 characters.
Cycle Time: This field sets the default cycle
time for the Axess. It accepts numeric
values from 1-99 only.
Delay Time: This field sets the default
delay time for the Axess. It accepts numeric
values from 0-99 only.
Current Alarm: This field is used to set the
High and Low Current alarms. The
maximum allowed value will change
depending on the model of the Axess. The
High and Low current alarms will accept
numeric values from 0.0 to 15.0 for 15 Amp models and 0.0 to 20.0 for 20 Amp models.
Voltage Alarm: This field is used to set the High and Low Voltage alarms. The High
alarm will accept numeric values from 135 to 150 and the Low alarm will accept numeric
values from 90 to 105.
Console Timeout: This field allows the specification of the amount of time that a
console session will remain active without any activity. This effects all CLI connections.
The field accepts numeric values from 30 to 3600. (30 seconds to 1 hour).
Baud Rate: This field allows the specification of the baud rate for the Axess serial port.
The choices are 2400, 4800, 9600, 19,200, 38,400 57,600 and 115,200 bits per second.
Country Code: The country code is used to set the modem’s country code. See
Appendix A for a list of country codes. This field is only displayed for models that have a
modem.
Upload Enable: This field is used to enable or disable the ability of the Axess to accept
firmware upgrades. When the check box is checked, the Axess will be able to accept
firmware upgrades.