StorCase Technology 9-Bay 4U SCSI Ultra160 - Manual (Page 19)

14 Installation
StorCase Technology, Inc. InfoStation Installation Guide - Rev. C01
RAID MODULE INSTALLATION
CAUTION: Remove ALL power from the InfoStation before installing the RAID
Module. The RAID Module contains NO USER SERVICEABLE PARTS in-
side the unit. Warranty is VOID if module is opened. Refer ALL ser-
vicing to qualified service personnel!
NOTES: The installation, configuration, and use of the RAID module option for the
StorCase™ InfoStation™ chassis requires a certain level of expertise and
experience on the part of the user/integrator. Since there are many con-
figuration options and variables (ie. host platforms, applications, etc), only
general guidelines will be discussed in this Installation Guide.
Installing the RAID Module into the InfoStation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the RAID module and InfoStation chassis. Also refer to the manufacturer's documentation
provided with the drive(s).
A #2 Phillips and a flat blade screwdriver will be required.
Removing the InfoStation Module Option Cover Plate
CAUTION: Remove ALL power from the InfoStation before removing any panels or cover
plates. The InfoStation contains NO USER SERVICEABLE PARTS inside the unit.
Refer ALL servicing to qualified service personnel!
1. Loosen and remove the three (3) #6-32 Phillips screws securing the module option
cover plate to the InfoStation chassis (Figure 13). Remove the cover plate.
2. Remove the remaining screw on the cover plate and disassemble into two pieces
(Figure 14). Save the smaller section, it will be used later in Step 2 of "Installing the
RAID Module into the InfoStation Chassis".
3. To reinstall cover plate, simply reverse the above mentioned steps.