StorCase Technology 9-Bay 4U SCSI Ultra160 - Manual (Page 12)

InfoStation Installation Guide - Rev. C01 StorCase Technology, Inc.
Installation 7
Figure 6: Removing and Installing the I/O Repeater Module
Removing and Installing the I/O Repeater Module
CAUTION: Remove ALL power from the InfoStation before removing the I/O repeater
module. The I/O repeater module contains NO USER SERVICEABLE PARTS inside
the unit. Refer ALL servicing to qualified service personnel!
NOTE: The I/O repeater module is NOT hot-swappable! Remove ALL power to chassis
before removing and installing the I/O repeater module.
1. Unplug the InfoStation and verify that all cables have been disconnected.
2. Place the InfoStation on a soft clean surface to protect finish of the chassis.
3. Loosen and remove the two (2) #6-32 Phillips Pan Head screws securing the I/O
repeater module to the InfoStation chassis (Figure 6).
4. Remove the I/O repeater module by grasping handle and pulling out from chassis.
5. To reinstall I/O repeater module, simply reverse above mentioned steps.
#6-32 Phillips
Head Screw
(2 places)
I/O Repeater
Module
InfoStation
Chassis
IFS_22