StorCase Technology DE200i-SWC - Manual (Page 31)

24 Appendix C - Attaching/Removing the ON/OFF Key
StorCase Technology, Inc. DE200i-SW/SWC User's Guide - Rev. C01
Appendix C - Attaching/Removing the ON/OFF Key
The DE200 comes from the factory with a power/lock key which is attached to the locking
mechanism. This key can be reconfigured by the user to be removable. To reconfigure, follow
the steps below.
1. Make certain power is OFF to the receiving frame.
Locate the rectangular shaped key lock mecha-
nism access hole on the inside of the receiving
frame. Note that the pawl is in an upright position.
Insert the key into the lock (skip this step if the key
is already fixed to the lock).
2. Rotate the key 90 degrees counterclockwise so
that the pawl is visible in the access hole as
shown in the figure at left.
3. Using the provided alignment tool, unscrew and
remove the pawl from the access hole.
4. Rotate the key 180 degrees clockwise.
5. Reinstall the pawl into the access hole with the
alignment tool.
The key lock has now been reconfigured.
Figure C-1: Reconfiguring the Key Lock Mechanism