StorCase Technology DE200i-SWC - Manual (Page 16)

DE200i-SW/SWC User's Guide - Rev. C01 StorCase Technology, Inc.
Installation 9
Figure 6B: Drive Installation Assembly
(DE200i-SWC)
Installation
(Applies to DE200i-SWC only)
1. Attach the 80-pin single-connect I/O cable from the rear distribution board of
the DE200i-SWC carrier to the drive (Figure 6B).
2. Carefully insert the drive into the carrier at an angle, cable-end first. Make sure
that the cable is not pinched. Lower the front of the drive carefully into
place. Fasten the drive into the carrier with four (4) #6-32 Phillips Flat Hd.
screws provided.
5. Attach the provided cable cover with two (2) #6-32 Phillips Flat Hd. screws.
Drive Carrier
Disk Drive
(Not Included)
I/O Cable
0151p
Cable
Cover
(Provided)
# 6-32 x 3/16
Phillips Flat HD
Screw (6 Total)