StorCase Technology DE200i-SWC - Manual (Page 28)

DE200i-SW/SWC User's Guide - Rev. C01 StorCase Technology Inc.
Appendix B - Factory-Installed Options 21
Figure B-1: Attaching the Hot Swap Board
Jumper Options
The jumper pins on the Hot Swap Board are similar to those on the SCSI Data Express
motherboard (Figure B-2). Removing the jumper at location JP1 will enable onboard receiving
frame termination. Location W1 provides remote ID selection. Jumper J4 Pins 4 & 6 provide
a signal to drive a remote activity LED (Pin 4 = Anode, Pin 6 = Cathode).
Using the Hot Swap Board
Carrier Removal
Follow the procedures below to remove the DE200 carrier from the receiving frame equipped
with the Hot Swap option.
1. Verify that the drive is not active. If the system is on a network, make certain other
users are not accessing the target drive, then disable it from the network. Dismount
the drive.