StorCase Technology DE200i-S User Manual

Page 18

DE200i-S User's Guide - Rev. D01

StorCase Technology, Inc.

Installation

Mounting
Holes (Right)

Mounting
Holes (Bottom)

Front of Unit

Mounting
Holes (Left)

0364

IMPORTANT NOTE: In order to use remote ID selection from a computer or expansion

chassis, the Unit ID number on the DE200i-S receiving frame

must be set to "0" with the provided alignment tool. Refer to the

section "Selecting the Unit ID Number" later in this User's Guide

for the Unit ID selection procedure.

With the drive carrier locked in place inside the receiving frame, install the

DE200i-S into the 5.25 drive opening in the computer or expansion chassis. Use

the appropriate guides to position the DE200i-S, and fasten it into place with the

four (4) #6-32 Phillips Pan Hd. screws provided. Figure 9 illustrates the location

of the mounting holes. Mounting holes are provided on each side and the bottom

of the receiving frame to accommodate a variety of mounting configurations. Use

the mounting holes which best suit the computer or expansion chassis

configuration.

Figure 9: Receiving Frame Mounting Holes

Adjust the front of the receiving frame so the carrier slides freely in and out on

the receiving frame guides. The position of adjoining peripheral units may require

adjustment.

To connect the drive to a Remote Activity LED in the computer system or

expansion chassis, connect the appropriate cable(s) to the receiving frame

motherboard as shown in Figure 5. Connect J6 Pins 4 & 6 to a remote activity

LED.

Connect the I/O cable from the host adapter to the receiving frame. The Pin 1

indicator on the cable must be properly aligned. Refer to Figure 5 for the correct

Pin 1 location.

Make sure that only the last SCSI device is terminated. If the DE200i-S is at the

end of a daisy chain, the terminators on the receiving frame must be enabled.

If the DE200i-S is in the middle of a daisy chain, termination should be disabled

(factory default). Refer to jumper W2 in Figure 5.