Spectrum Controls 1746sc-INO4vi - Manual (Page 25)

Using Your Output Module
Read this chapter to:
• enter your output module’s ID code
• configure each output channel
• set the output data limits or user-defined scale (optional)
• control each output channel’s signal
• monitor each output channel
• check each output channel’s configuration and status
To use your module, you need:
• programming equipment
• Allen-Bradley Advanced Programming Software (APS)
For help with APS, see the Getting Started Guide for APS.
Entering Your Module’s
ID Code
Before using your module, you must configure the slot your module is in
by entering your module’s ID code in APS.
When using APS version 6 or later, simply select your module from the
list of modules on the system I/O configuration display to automatically
enter the ID code.
With earlier versions of APS (4 through 5), you must manually enter the
ID code. To enter your module’s ID code, select “other” from the list of
modules on the APS system I/O configuration display, and enter your
module’s ID code at the prompt. The module ID code for your module is:
Table 8. Output module ID code
Catalog Number Module ID Code
1746sc-INO4i 3521
1746sc-INO4vi 3519
Chapter 4