Directed Electronics G312R - Manual (Page 37)

34 © 2 0 0 3 d i r e c t e d e l e c t r o n i c s , i n c .
ttrra an nssm miitttte err//rre ec ce eiivve err
lle ea arrn n rro ou uttiin ne e
The system comes with 2 transmitters that have been taught to
the receiver. The receiver can store up to 4 different transmitter
codes in memory. Use the following learn routine to add trans-
mitters to the system or to change button assignments if desired.
The Disarm/Program switch, plugged into the blue port, is used for
programming. There is a basic sequence of steps to remember when-
ever programming this unit: Key, Choose, Transmit and Release.
1. K Keeyy.. Turn the ignition to the ON position.
2. C Ch hoooossee.. Within 10 seconds, press and
release the Disarm/Program switch the
number of times for the desired function (see
chart below). Then press the switch once more
and hold it. The horn will honk and the LED
will flash to confirm the selected channel. Do
not release the Disarm/Program switch.