Directed Electronics G312R - Manual (Page 31)

28 © 2 0 0 3 d i r e c t e d e l e c t r o n i c s , i n c .
T TW WO O--R RE ESSIISST TO OR R T TY YP PE E:: If two resistors are used in the factory
door lock switch/key cylinder, the door lock switch/key cylinder
will read resistance to ground in both directions.
D DE ET TE ER RM MIIN NIIN NG G T TH HE E P PR RO OP PE ER R R RE ESSIISST TO OR R V VA AL LU UE ESS:: To
determine the resistor values, the door lock switch/key cylinder
must be isolated from the factory door lock system. For testing, use
a calibrated digital multimeter that is set to ohms.
IIM MP PO OR RT TA AN NT T:: To ensure an accurate resistance reading, do not touch
the resistor or leads during testing.
1. Cut the output wire from the door lock switch/key cylinder in
half.
2. Test with the meter from the switch side of the cut door lock
switch/key cylinder wire to a reliable ground source. Some good
ground references are the ground input source to the door lock
switch/key cylinder or the battery ground.
3. Operate the door lock switch/key cylinder in both directions to
determine the resistor values. If the multimeter displays zero
resistance in one direction, no resistor is needed for that direc-
tion.
4. Once the resistor value(s) is determined, refer to the wiring dia-
gram for proper wiring.