Rocktron Replifex - Manual (Page 65)

62
Operating the Replifex ™
Step 4 Press the STORE button at this time to initiate the All Restore procedure and erase all current
Replifex
™ presets, replacing them with the original factory presets. The Replifex ™ will display
"INITIALIZING" as the Replifex ™ memory is restored.
INITIALIZING
After the All Restore process is completed, the display should read "ERRORS 0". This is the
number of bytes that the Replifex
™ found that did not initialize properly. Any number of
errors other than "0" means that the Replifex ™ may not have initialized properly and the
process should be repeated.
ERRORS 0
The Replifex ™ will remain in this condition until the FUNCTION SELECT control is
turned to exit the Factory Restore function. The preset currently recalled will be the preset
most recently restored into the current location.
The controller assignments for the Replifex ™ can also be reinitialized without
affecting presets and other stored information. Reinitialization of the controller assign-
ments is necessary when setting up the Replifex ™ to operate in remote mode with a
Rocktron All Access ™ footswitch.
To reinitialize only the controller assignments, enter a code number of "244" at
Step 3 on the preceding page (instead of the "243" shown).
Restoring the Replifex ™ controller assignments: